Publicité
Les langues disponibles
Les langues disponibles
on the cooker.
c) In the mode of "Lock", press "Lock button" for 3 seconds again, lock indicator goes out, the control
panel is unlocked.
8. Fan Keeps Working
a) The fan will keep working for 2 minutes to 5 minutes for heat dissipation after finish cooking. It will stop
automatically until the glass surface temperature below 50°C.
9. Automatically Switch Off When No Operation for 2 Hours
a) In working mode, the cooker will automatically switch off if without any operation after 2 hours
except the mode of timer.
10. High Temperature Indicator
a) After turn off, the LED display screen shows "-H-" (High Temperature Indicator), it will disappear only
after the glass surface temperature below 50°C.
MAINTENANCE
1. Turn off the appliance by pressing button "On/Off" and wait until the light turns off. Once off, unplug the
power cord properly.
2. Wait for some time and let the appliance cool down.
3. You can use mild detergent or dishwashing liquid with a soft cloth to remove dirt.
4. Do not clean it with running water or immerse it in water as water will get inside and damage the appliance.
5. Always make sure that the top plate and the pan/pot is clean before cooking as the dirt from the pan/pot will
stick to the plate and plate will get discolored.
6. You may clean the air vent by vacuum cleaner to suck up the dirt or you can use cotton if the dirt is with oil.
7. Toothbrush with little soap can also be used to clean the surface as long as you use it gently on the appliance.
8. Do not use abrasives or strong detergents as it may get chemical reaction.
9. After dirt has been removed, use a dry, soft cloth to wipe dry the appliance.
TROUBLE
Power indicator not on
Power off automatically
LED shows E0
LED shows E2
LED shows E3
LED shows E4
LED shows E5
LED shows E6
INSTRUCTIONS FOR DISPOSAL
DT Istr (PI-2000) 04/17_Rev. 0
TROUBLE SHOOTING
POTENTIAL CAUSES
Power cord is not connected
well
1. Spare parts over heat
2. No operation in two hours
1. No pot
2. Pot too small
Temperature sensor open circuit
or short circuit
High voltage protection
Too low voltage protection
High temperature protection
IGBT overheat
RESOLUTION
Please ensure the plug inserted
into the socket
Please
restart
the
otherwise, return it to the service
center for checking and repairing
Put the suitable pot on the surface
of the cooker. It will return to the
state of power on if without any
operation for 30 seconds.
Please return the cooker to the
service center for checking and
repairing
Please ensure 150V＜voltage ＜
270V.
Please ensure 150V＜voltage ＜
270V.
Start again after the temperature
cool down
Please check if the air intake and
outlet is jammed. If not, please
return the cooker to the service
center for checking and repairing
PI-2000
cooker,
17/19
Publicité
