Publicité
Les langues disponibles
Les langues disponibles
7
LED Display Screen
LEVEL SETTINGS OF POWER AND TEMPERATURE
Watt (W)
200
Temp (℃)
60
FUNCTIONING
Place the induction plate on a flat surface, stable and away from sources of water. Connect the electrical plug to
a socket approved according to the safety requirements for electrical installations of civil type, with a nominal
voltage identical to that of the appliance and equipped with a ground wire.
Always use cookware (pots, pans, plates, etc.) with flat bottom.
1. Power On
a) When power on, the buzzer alerts, all LED display and indicators glisten one time and disappear, the
cooker enters into power on condition.
2. Switch On
a) After power on, press "On/ Off Button", the LED screen shows "1000" (Watt), power indicator keeps
consistent on, "Timer LED" and "Function Button" indicator are flashing, the cooker is ready for working.
b) After switch on, press "Function Button" to select power heating function or temperature heating function.
c) If in the temperature heating function, the LED screen shows "120" (Degree Centigrade), power indicator
keeps consistent on, "Temperature LED" and "Function Button" indicator are flashing, the cooker is ready
for working.
d) Press "Decrease Button" or "Increase Button" to start to work.
e) The cooker will return to the state of power on if without any operation for 30 seconds after switch on.
3. Switch Off
a) When in working or switch on, press "On/ Off Button", the cooker will stop working and enters into power
on condition.
4. Timer
a) Time range from 1 minute to 180 minutes.
b) After switch on, press "Timer Button", the LED screen shows "0". Pressing "Decrease Button" the time
will decrease 1 minute every step. Instead pressing "Increase Button" the time will increase 10 minute
every step. It will be automatically confirmed in 5 seconds after you set the time.
c) In the mode of Timer, the LED will show power/temperature and timer alternately every 5 seconds.
d) After timer ends, it will get back to the state of power on.
e) Press "On/Off Button" to cancel the timer function.
5. Power Heating Function
a) When in switch on or other cooking modes, press "Function Button" to select power heating function or
temperature heating function.
b) If in the power heating function, the LED screen shows "1000" (Watt), power indicator keeps consistent
on, "Power LED" and "Function Button" indicator are flashing, the cooker is ready for working.
c) Press "Decrease Button" or "Increase Button" to start to work.
d) In the mode of Timer, the LED will show power and timer alternately every 5 seconds.
6. Temperature Heating Function
a) When in switch on or other cooking modes, press "Function Button" to select power heating function or
temperature heating function.
b) If in the temperature heating function, the LED screen shows "120" (Degree Centigrade), power indicator
keeps consistent on, "Temperature LED" and "Function Button" indicator are flashing, the cooker is ready
for working.
c) Press "Decrease Button" or "Increase Button" to start to work.
d) In the mode of Timer, the LED will show temperature and timer alternately every 5 seconds.
7. Lock
a) Press "Lock Button"，lock indicator keeps consistent on, the cooker enters into lock function. During
this mode, it will lock the control panel except the "On/Off Button ".
b) In the mode of "Lock", press "On/Off Button" to turn off the cooker, lock indicator will keep
consistent on, press "Lock Button" for 3 seconds again to unlock the panel and then you could turn
DT Istr (PI-2000) 04/17_Rev. 0
400
600
800
80
100
120
14
On/Off Button
1000
1200
1400
140
160
180
1600
1800
2000
200
220
240
PI-2000
16/19
Publicité
