Nicols LED BAR 123 FC IP Manuel D'utilisation page 8

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

installation, operation and maintenance.
Please keep this User Manual for future consultation. If you sell the unit to another user, be
sure that they also receive this instruction booklet.
Unpack and check carefully there is no transportation damage before using the unit.
Before operating, ensure that the voltage and frequency of power supply match the power
requirements of the unit.
It‟s important to ground the yellow/green conductor to earth in order to avoid electric shock.
The unit is for indoor and outdoor use.
The unit must be installed in a location with adequate ventilation, at least 50cm from
adjacent surfaces. Be sure that no ventilation slots are blocked.
Disconnect mains power before fuse replacement or servicing.
Make sure there are not flammable materials close to the unit while operating as it is fire
hazard.
Use safety cable when fixes this unit.
Maximum ambient temperature is 40°C and don‟t operate it where the temperature is higher
than this.
There are no user serviceable parts inside the fixture. Do not open the housing or attempt
any repairs by yourself. In the unlikely event your fixture may require service, please contact
the nearest authorized technical assistance center and always use the same type spare
parts.
The housing must be replaced if they are visibly damaged.
Do not touch any wire during operation as high voltage may cause electric shock.
Do not look directly at the LED light beam while the fixture is on.
Do not look at the beam light directly to avoid any visual problems.
Possibly hazardous optical radiation emitted from this product.
2. Technical specifications
Weight: 3.8kg
Size: 11.4 x 12 x 12 cm
Power input: AC230V/50 HZ
Wattage: 60W
LEDS: 12*tri-3W LEDs
Beam angle: 40 degree
IP rate: IP65
7-

Publicité

Table des Matières
loading

Table des Matières