Publicité
Les langues disponibles
Les langues disponibles
Key (with indicator)
ON/OFF
POWER
ICE FULL
ADD WATER
1. Unpack the appliance, then check and make sure that all the accessories including ice
basket and ice scoop etc. are included. Please contact the client service department
if some accessories are missed.
2. Please ensure the ice maker is level and on a stable table or platform to avoid
malfunction.
3. The incline angle of the ice maker cabinet should not exceed 45° during transportation
or use. Do not turn the ice maker upside down. Doing so could cause the compressor or
refrigerating system to operate incorrectly. Please allow time for the fluids in the
compressor to settle after the ice maker is moved or transported. Before using the ice
maker for the first time, please wait for 2 hours after the unit has been leveled and
positioned in the proper place.
4. The appliance must be placed on a dry and level surface with sufficient ventilation, far
from heat sources such as ovens, heaters and corrosive gases. Leave about a 6-inch
(15cm) clearance on all sides of the ice maker for proper ventilation.
5. Do not fill the water reservoir with hot water. This may damage the ice maker. It is
best to fill the water reservoir with water of room temperature or lower.
6. Do not use the appliance in a very cold environment (lower than 5℃).
7. Clean the appliance by following the operation of "CLEANING AND
MAINTENANCE" before you operate.
Function
Start or stop the appliance
Standby mode: "POWER" indicator blinks;
Working condition: "POWER" indicator
lights solidly.
"ICE FULL" indicator lights up when the
ice basket is full.
"ADD WATER" indicator lights up when
the water reservoir is lack of water.
5
Publicité
