Safety Instructions
A
1.3. Electrical safety
•
The product shall not be plugged into the
outlet during installation, maintenance,
cleaning, repair, and transportation
operations.
•
If the power the cord is damaged, it shall
be replaced by authorized service only to
avoid any risk that may occur.
•
Do not tuck the power cord under the
product or to the rear of the product. Do
not put heavy items on the power cord.
The power cord should not be bent,
crushed, and come into contact with any
heat source.
•
Do not use an extension cord, multi- plug
or adaptor to operate your product.
•
Portable multi sockets or portable power
supplies may overheat and cause fire. Thus,
do not have a multi- plug behind or in the
vicinity of the product.
•
The plug shall be easily accessible. If this is
not possible, a mechanism that meets the
electrical legislation and that disconnects
all terminals from the mains (fuse, switch,
main switch, etc.) shall be available on the
electrical installation.
•
Do not touch the plug with wet hands.
•
When unplugging the appliance, don't hold
the power cord, but the plug.
A
1.4. Handling Safety
•
This product is heavy, do not handle it by
yourself.
•
Do not hold the product from its door while
handling the product.
•
Be careful not to damage the cooling
system and the pipes while handling the
product. Do not operate the product if the
pipes are damaged, and contact an
authorized service.
A
1.5. Installation Safety
•
Contact the Authorized Service for the
product's installation. To prepare the
product for installation, see the information
in the user guide and make sure the electric
and water utilities are as required. If the
installation is not suitable, call a qualified
electrician and plumber to have them make
the necessary arrangements. Otherwise,
electric shock, fire, issues with the product
or injuries may occur.
•
Check for any damage on the product
before installing it. Do not have the product
installed if it is damaged.
•
Place the product on a level and hard
surface and balance with the adjustable
legs. Otherwise, the refrigerator may tip
over and cause injuries.
•
The product shall be installed in a dry and
ventilated environment. Do not keep
carpets, rugs or similar floor covers under
the product. This may cause risk of fire as a
result of inadequate ventilation!
•
Do not block or cover ventilation holes.
Otherwise, power consumption may be
increased and damage to your product may
occur.
•
Do not connect the product to supply
systems such as solar power supplies.
Otherwise, damage to your product may
occur as a result of the abrupt voltage
fluctuations!
•
The more refrigerant a refrigerator
contains, the bigger its installation room
shall be. In very small rooms, a flammable
gas-air mixture may occur in case of a gas
leak in the cooling system. At least 1 m
volume is required for each 8 grams of
refrigerant. The amount of the refrigerant
available in your product is specified in the
Type Label.
•
The installation place of the product shall
not be exposed to direct sunlight and it
shall not be in the vicinity of a heat source
such as stoves, radiators, etc.
04 / 21 EN
Refrigerator / User Manual
of
3