BaByliss Paris Homelight 930 Mode D'emploi page 57

contact with your skin, it will not release a pulse of light. Make sure, therefore, that the application surface
is correctly applied to your skin.
8. Press the release mechanism. The appliance will release a pulse of light. You may feel a slight warm and
tingling sensation.
9. Remove the application surface from the treated patch of skin.
10. Move the application surface to another area to be treated. Pressure marks left on your skin by the
application surface should help you to correctly align the epilator to administer the next pulse, avoiding
the release of two pulses on the same patch of skin or too much space being left between the patches.
(see 'Covering the area to be treated'). Your Homelight appliance will recharge immediately after each
pulse. After 1,6 second (at level 1), the 'Ready' indicator light will come on again. The appliance is now
ready to release another pulse.
Warning: Never treat the same patch of skin more than once per depilation session!
Repeated treatment of the same area increases the risk of side effects.
6.4. Modes of use
PRECISION mode
The Precision Mode, as described under points 7 to 10 above, allows for safe treatment of the least
accessible and most sensitive areas of your body (face, underarms, bikini line, etc.). Be careful when treating
your face. Make sure you attach the special face filter (only available on selected models) on the appliance
head (see the section "Epilation of the face with Homelight").
GLISS mode
When the applicator window is properly applied to the skin and the release mechanism is held in, the user
can activate the Gliss mode (continuous release of 36 pulses per minute, at level 1). In this way, there is an
automatic continuous release of pulses without the need for additional handling. You can thus easily slide
the appliance over your skin without interruption in a slow and continuous movement without lifting or
lowering it.
57