Samsung NV51K6650 Serie Manuel D'installation page 13

Electrical connection
For Double Ovens
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Use 8 gauge solid copper wire.
Make sure to ground the oven.
Failure to follow these instructions can result in death, fire, or electrical shock.
This oven is manufactured with a neutral (white) power supply wire and a cabinet-
connected ground (green or bare) wire twisted together.
A
A. UL listed or CSA approved
conduit connector
For Single Ovens
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Use 8 gauge solid copper wire.
Electrically ground oven.
Failure to follow these instructions can result in death, fire, or electrical shock.
Install_NW9000K_DG68-00862A-09_EN.indd 13
1. Disconnect power.
2. Feed the flexible conduit from the oven
through the opening in the cabinet.
3. Remove junction box cover if it is
present.
Install a UL listed or CSA approved
4.
conduit connector to the junction box.
5. Route the flexible conduit from the
oven to the junction box through a
UL listed or CSA approved conduit
connector.
6. Tighten screws on conduit connector.
See "Electrical Connection Options
7.
Chart" to complete installation for your
type of electrical connection.
Electrical Connection Options Chart
If your home has:
4-wire
4-Wire Cable from Home Power Supply
½"
(1.3 cm)
3-wire
3-Wire Cable from Home Power Supply
½"
(1.3 cm)
NOTE
If the power connection is plugged in improperly, "bAd LinE" appears on the
display.
Reconnect the power connection properly, and the message disappears.
Go to section:
English 13
2019-11-11 5:36:08