stayer MULTI TOOL 300 Instructions D'emploi page 13

Noise/Vibration Information
Measured sound values determined according to EN
60745. Typically the A-weighted noise levels of the product
are: Sound pressure level 81 dB(A);
Sound power level 92 dB(A). Uncertainty K=3 dB.
Wear hearing protection!
Vibration total values (triax vector sum) determined
according to EN 60745:
Sanding: Vibration emission value ah=2 m/s2, uncertainty
K=1.4 m/s2
Cutting with plunge cut saw blade: Vibration emission
value ah=10 m/s2, uncertainty K=1.5 m/s2
Cutting with segmential saw blade: Vibration emission
value ah=6.5 m/s2, uncertainty K=1.5 m/s2
Scraping: Vibration emission value
ah=4.5 m/s2, uncertainty K=1.5 m/s2.
The vibration emission level given in this information sheet
has been measured in accordance with a standardised
test given in EN 60745 and may be used to compare
one tool with another.It may be used for a preliminary
assessment of exposure.
The declared vibration emission level represents the main
applications of the tool. However if the tool is used for
different applications, with different accessories or poorly
maintained, the vibration emission may differ. This may
significantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibration should
also take into account the times when the tool is switched
off or when it is running but not actually doing the job. This
may significantly reduce the exposure level over the total
working period.
Identify additional safety measures to protect the operator
from the effects of vibration such as: maintain the tool and
the accessories, keep the hands warm, organisation of
work patterns.
3. Assembly Changing the Tool
Before any work on the machine itself, pull the mains
plug.
Wear protective gloves when changing application
tools/accessories. Contact with the application tool/
accessoriy can lead to injuries.
Selecting the Application Tool/Accessory
ENGLISH
13
Mounting/Replacing the Application Tool/ Accessory
180 Turn the lever 7 to extract useful and change it. Return
around to fix the tool.
Check the tight seating of the application tool/
accessory.
Incorrect or not securely fastened application tools/
accessories can come loose during operation and pose
a hazard.
Mounting/Replacing a Sanding Sheet on the Sanding
Plate
The sanding plate 9 is fitted with Velcro backing for
quick and easy fastening of sanding sheets with Velcro
adhesion.
Before attaching the sanding sheet 10, free the Velcro
backing of the sanding plate 9 from any debris by tapping
against it in order to enable optimum adhesion. Position
the sanding sheet 10 flush alongside one edge of the
sanding plate 9, then lay the sanding sheet onto the
sanding plate and press firmly.
To ensure optimum dust extraction, pay attention that the
punched holes in the sanding sheet match with the holes
in the sanding plate.
To remove the sanding sheet 10, grasp it at one of the tips
and pull it off from the sanding plate 10.
Selecting the Sanding Sheet
Depending on the material to be worked and the required
rate of material removal, different sanding sheets are
available:
13
Accessory Material
HSS wood Wooden
segment saw materials, plastic
blade
BIM segment Wooden
saw blade materials, plastic
Base plate for Wooden
sanding, series materials,
Delta 93 mm. plastic, gypsum
and other soft
materials
HSS plunge Wood,
cut saw blades, non-
wood metals
BIM plunge cut Metal
saw blades, unhardened
metal nails,
smaller profiles),
non-
metals
BIM plunge cut Depends
saw blade, wood sanding sheet
and metal
metal,
ferrous
(e.g.
screws,
ferrous
on