Delachaux CONDUCTIX wampfler 040836-09,0x2,7 Instructions D'utilisation page 10

Operating Instructions
Balancer
040836-...x2,7
1 Safety instructions
Hazard-free work with the device is only possible if you completely read the operating instructions and safety instructions and
•
strictly follow the advisories contained therein.
Each change of the Balancer and of the accessories must only be performed with the expressed written consent of the
•
manufacturer.
The Balancer must only be operated, installed, maintained and serviced by trained and informed personnel. The personnel
•
must be instructed with regard to the possible hazards involved in these tasks.
The Balancer must only be used for the intended purpose.
•
Check attachment to supports, etc. intended for use with the Balancer.
•
Spring unit: Do not dismantle the spring housing! Dismantling is extremely dangerous and strictly prohibited.
•
The cable of the Balancer must be periodically checked for damage.
•
If the cable is damaged, the Balancer must not be operated.
Always use a separate safety chain.
•
Suspension, fall protection and safety chain must be continuously monitored. If damage is discovered, the Balancer is to be
•
replaced immediately.
Note that a resiling of the cable in a non-loaded state poses severe danger to persons in addition to resulting in the
•
destruction of the spring.
Never work beneath suspended loads.
•
The maximum loading capacity according to the type plate must not be exceeded. The Balancer must only be operated within
•
the specified loading capacity range.
Always have a good view of things when handling the load. The load must not be moved with full force against the limit stops.
•
If necessary, adjust to the appropriate working height.
Pull out the cable to its full length and loosen the spring force before the spring unit is disassembled.
•
Use only genuine replacement parts when performing repairs or maintenance.
•
2 Installation / Commissioning
Before installing the Balancer, it must be ensured that the device to which the Balancer and the fall protection mechanism are
•
attached have adequate stability.
Versions with plastic housing must not be positioned near heated air fans.
•
To guarantee perfect functioning, the Balancer must be able to move freely in order to enable shuttling in the cable pull
•
direction.
Regularly check the moving parts in the hook block.
•
BAL0402-004-D/E/F
www.conductix.com Page 10 of 20