Pur Line HYDRO 13 Manuel D'utilisation page 9

Remove the water tank.
Turn the tank upside down and open the lid.
Fill with clean cold water (max. 40ºC).
Close the water tank cap.
Install the water tank in the humidifier body.
AROMATHERAPY FUNCTION: add a few drops of essential oil into the aromatherapy box, located on the top
of the device.
CONTROL PANEL
REMOTE CONTROL: has the same functions that the control panel.
CLEANING AND MAINTENANCE
In case when the water is hard which means water contains too much calcium and magnesium, they can cause
"white powder" problem and give heavy scum on the surface of water basin, transducer and inner surface of
the water tank. Scum on the surface of transducer will make the unit work improperly.
WE RECOMMEND:
• Use filtered water or distilled water.
• Clean the transducer, water tank and basin unit every week.
• Change the water in water tank more often to keep it fresh.
• Clean the whole unit, and make sure to keep all parts of the unit dry completely when the unit is not in use.
HOW TO CLEAN THE TRANSDUCER:
1. Put 5-10 drops of vinegar on the surface of the transducer, wait for 2-5 minutes.
2. Brush out the scum on the surface.
3. Rinse the transducer with clean water.
HOW TO CLEAN THE BASIN UNIT:
1. Clean the water basin with soft cloth and the vinegar if there is scum in it.
2. If the scum is covered on the security switch, drop the vinegar on the scum and clean it out with the brush.
3. Rinse the water basin with clean water.
EN
ON/OFF button: press to turn on/off the device.
ANION button: press to turn on the ionization function.
The ionization indicator will be on. Press again to turn the
function off.
HUMIDIFY button: press to adjust the amount of mist
generated by the device: 1- low, 2- medium, 3- high. The
display shows the number of the current level (1, 2 or 3).
HYGROSTAT button:
humidification and set a desired humidity level (45, 50, 55, 60,
65, 70, 75, 80, 85 or 90% RH). The device operates until the set
humidity level is reached and then it turns off automatically.
When the device is on, the display shows the current room
humidity level. When the water level in the tank is too low,
the device beeps and turns off automatically.
TIMER button: press to define how long you want the
humidifier to work before it automatically turns off: 1 hour,
2 hours, 4 hours and 8 hours. The display will show the
remaining time.
SLEEP button: press to turn the display backlight on or off.
7
press to start the automatic