Publicité
Les langues disponibles
Les langues disponibles
REPLACEMENT OF THE SPRING
The spring which allows to rewind the hose is placed inside a proper housing center which is joint to the
drum.
WARNING! The disassembly of the spring is only permitted to the staff authorized and suitably
trained by the manufacturer. Handle with the greatest care the spring.
12.1) Make sure that the rewinding system is to- tally
unloaded and that the drum is free (see point 11.1)
12.2) Loosen the swivel joint.
12.3) Loosen the two screws of the spring linkage shaft by a
10 mm wrench (see point 11.3).
12.4) 12.4) Disassemble the opening on the spring side by a
10 mm wrench and take out the drum.
12.5) Take out the shaft from the spring housing.
12.6) Lift the tangs on the drum by a screwdriver and rotate
the spring housing center in order to release it from the
drum.
12.7) Turn upside down the drum and take out the spring
housing center paying the greatest care so that the spring
does not go out of it.
12.8) Insert and hook the shaft into the new spring housing
center. Lubricate the spring and the shaft.
12.9) Put the drum straight and place the new spring
housing center with the utmost care. Block the tangs.
12.10) Assemble all the parts and go on as indicated at point
7.2 of the chapter «Mounting of the hose»
18
Publicité
