Publicité
Les langues disponibles
Les langues disponibles
REPLACEMENT OF THE HOSE
The hose must always be replaced with an original hose ordered from an authorized distributor.
To change the hose, please follow the steps below:
11.7) Go on as indicated at point 7.2 by rotate manually the drum in order to rewind completely the hose.
7.3) Hold the hose-end and rotate the drum 9 turns in the opposite direction to pre-load the spring. Insert
again the hose-end between the guide rollers. 7.4) Put the hose rubber stopper at the desired length.
Unwind the hose and rewind it completely, to check if the hose reel works properly.
11.1) Remove the hose rubber stopper and release the hose slowly until the
spring is completely unloaded.
11.2) Loosen the swivel joint.
11.3) Loosen the screws of the spring linkage shaft.
11.4) Disassemble the opening on the spring side and unwind completely
the hose from the drum.
11.5) Take out the drum, unscrew the internal fitting with the suitable
wrench and mount the new hose.
11.6) Assemble again the hose reel, by following the above steps in reverse
order. If that is the case, grease the supports and the ratchet hook.
17
Publicité
