HYCKES HYCOOLER GO 8 Notice D'utilisation page 6

Masquer les pouces

page de 24

/ 24
Signets

Les langues disponibles

Cleaning and maintenance

Cleaning

Occasionally clean the cooler with a damp cloth and leave it to dry.

–

Make sure the cooler is disconnected from the power supply before cleaning to avoid

electric shocks.

–

If the optional Powerpack is installed, remove the battery from the compartment and

place the compartment cover back in place.

–

Do not soak the device in water or clean it under running water.

–

Do not use hard objects or abrasive cleaning agents as these can damage the device.

–

Periodically check the air inlet and outlet vents for dust or dirt blocking the airflow.

Defrosting

The cooler must be defrosted from time to time. Due to humidity, frost can settle on the

evaporator and will reduce the cooling capacity of the device.

–

Make sure the cooler is disconnected from the power supply before cleaning to avoid

electric shocks.

–

If the optional Powerpack is installed, remove the battery from the compartment and

place the compartment cover back in place.

–

Never use sharp objects to defrost the device as they can damage the refrigerant circuit.

–

Do not use mechanical objects or other means speeding up the defrosting process as

they can damage the device.

–

Remove the melt water (by removing the drain plug if applicable)

–

Clean with a damp cloth and leave it to dry.

Storage

When the device is left unused for a longer period of time:

–

Disconnect the power cable and make sure the device is switched off.

–

If the optional Powerpack is installed, remove the battery from the compartment and

place the compartment cover back in place.

–

Leave the device for some time to defrost.

–

Clean and dry the device.

–

To prevent moulds and odours developing within the cooling compartment, take off the

lid or leave it opened.

HyCooler Go

Troubleshooting

When there are issues with the cooler during use, please refer to the troubleshooting list below.

If this does not resolve the issues, please contact a local retailer or visit www.hyckes.com.

Issue

The device does not function.

The device cannot be controlled by app.

There is a bubbling or sizzling sound coming

from the cooling compartment.

The compressor is slightly noisy when start-

ing.

A fault code is shown on the display.

In case the display of the cooler shows a fault code (Fx), the following table explains the meaning

of this fault code and a possible cause and suggestion to resolve this fault.

Fault code

Possible cause

Low input voltage

Cooling fan over temperature

Compressor started too frequently

Compressor start fail

Compressor over temperature

No parameter can be detected

F7 or F8

Temperature sensor defect

HyCooler Go

Possible cause or suggestion

Check if the power cable and plugs are connected

correct.

The power supply gives no voltage, try another

power outlet or socket.

A fuse has been blown, please check and replace

the fuse.

Restart the app on your mobile device, or (re)con-

nect Bluetooth. See paragraph 'app connection'.

This is a normal phenomenon, caused by the flow of

refrigerant.

This is a normal phenomenon, the sound will reduce

after some time running.

Please check the table below.

Suggestion

Check supply battery power, or change

battery protection mode to medium or low. In

case the optional battery is installed; remove

or turn off the battery, or connect a power

supply to prevent draining the battery.

Turn off the device for 5 minutes, then re-

start. Contact an authorised repair centre for