Publicité
MAINTENANCE
Changing the Blade
Use the provided Allen wrench to
remove the nine screws, then hold
the blade by each end and carefully
move the blade out of blade holder.
Note: the flat side of the blade
should face the working table
when installing a new blade.
Warning: Do not put your fingers
against the sharp edge of the blade
at any time.
Changing the Nylon Bar
Use the provided Allen wrench to
remove the ten screws, then hold
the nylon bar and carefully move
it out of nylon bar holder.
Warning: Do not put your fingers
against the sharp edge of the
blade at any time.
Transport
Lock the handle in the down
position by sliding the locking pin
on the eccentric cam as shown.
Carry the cutter using the table
opening as shown
– 4 –
Publicité
