Publicité
SET UP
Installation Install the wheel assembly to the cutter base
with provided bolts and nuts as shown.
Then insert the handle into the handle base as show and
tighten provided screw.
Warning: Do not put your fingers against the sharp edge of
the blade at any time.
CUTTING
45° Cut
Adjust the angle attachment
to 45°. Insert material between
the cutting blade and the base,
against the angle attachment as
shown, then press the handle
down to complete a cut.
Warning: Maintain control of the
handle. Do not allow handle to
slam back after making a cut.
– 3 –
Publicité
