Hilti NURON SF 6-22 Mode D'emploi page 28

4.3 Noise information and vibration values in accordance with EN 62841
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a
preliminary assessment of exposure.
The data given represent the main applications of the power tool. However, if the power tool is used for
different applications, with different accessory tools, or is poorly maintained, the data can vary. This can
significantly increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times when the tool is switched off, or
when it is running but not actually being used for a job. This can significantly reduce exposure over the total
working period.
Identify additional safety measures to protect the operator from the effects of noise and/or vibration, for
example: maintaining the power tool and accessory tools, keeping the hands warm, organization of work
patterns.
Noise emission values
Emission sound pressure level (L
Uncertainty for the sound pressure level (K
Sound power level (L
WA
Uncertainty for the sound power level (K
Total vibration
Vibration emission value for
drilling in metal (a )
h,D
Uncertainty for drilling in metal (K)
Vibration emission value for
hammer-action drilling in
concrete (a )
h,ID
Uncertainty for hammer-action drilling in concrete
(K)
5 Preparations at the workplace
WARNING
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1 Charging the battery
1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery. → page 19
5.2 Inserting the battery
WARNING
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the product until it engages with an audible click.
22 English
)
pA
)
pA
)
)
WA
B 22­85
B 22­170
B 22­85
B 22­170
SF 6-22
74.5 dB(A)
5 dB(A)
85.5 dB(A)
5 dB(A)
SF 6-22
1.0 m/s²
0.7 m/s²
1.5 m/s²
•/•
•/•
•/•
2275217
*2275217*
SF 6H-22
94.5 dB(A)
5 dB(A)
105.5 dB(A)
5 dB(A)
SF 6H-22
1.2 m/s²
1.1 m/s²
1.5 m/s²
11.9 m/s²
10.6 m/s²
1.5 m/s²