Publicité
Les langues disponibles
Les langues disponibles
For devices with DVI output
TV
Audio cable
HDMI-DVI Conversion cable
AV Equipment (e.g. Blu-ray Disc player)
Network
●
To enable the network service functions, you need to
connect the TV to a broadband network environment.
If you do not have any broadband network services,
please consult your retailer for assistance.
●
Prepare the Internet environment for wired connection
or wireless connection.
■
Wired connection
TV
LAN cable (Shielded)
●
Use Shielded Twist Pair (STP) LAN cable.
■
Wireless connection
Built-in wireless LAN (Rear of the TV)
Access point
■
About built-in wireless LAN/Bluetooth
●
To use the built-in wireless LAN, using an access
point is recommended.
●
To use the built-in wireless LAN in the access point
mode, up to 7 devices are connectable. But the
transfer rate will vary according to communication
environment or connected equipments.
●
Do not use the built-in wireless LAN to connect to any
wireless network (SSID*
usage rights. Such networks may be listed as a result
of searches. However, using them may be regarded
as illegal access.
Internet environment
Internet
environment
) for which you do not have
1
●
Check that the Access point supports WPS*
(If it does not support WPS, the encryption key of the
Access point is required when configuring settings.)
●
Follow the instructions on the Access point setup
screen and configure the appropriate security
settings.
For more details on setting of Access point, please
refer to operating manual for the Access point.
●
We recommend using 11n (5 GHz) for the wireless
system between the built-in wireless LAN and Access
point.
Communication is also possible with 11a, 11b, and
11g, but the communication speed may be slower.
●
If the wireless system of the Access point is changed,
devices that could connect by wireless LAN may no
longer be able to connect.
●
Data transmitted and received over radio waves may
be intercepted and monitored.
Keep the TV away from the following devices as much
as possible:
Wireless LAN, microwaves, and other devices that
use 2.4 GHz and 5 GHz signals. Otherwise, the TV
failures such as malfunction may occur due to the
radio wave interference.
●
When noises occur due to the static electricity, etc.,
the TV might stop operating for the protection of the
devices. In this case, turn the TV Off with power On /
Off switch, then turn it On again.
*1 SSID is a name for identifying a particular wireless
network for transmission.
*2 WPS: Wi-Fi Protected Setup
Other connections
To use COMPONENT terminals
(DVD recorder / Blu-ray Disc player / etc.)
TV
(Viewing)
AV Equipment (e.g. Blu-ray Disc player)
Audio cable (Shielded)
Component video cable (Shielded)
.
2
(Listening)
13
English
Publicité
