Publicité
Les langues disponibles
Les langues disponibles
Installing Your Beverage Cooler
Unpacking Your Beverage Cooler
1. Remove all packaging material. This includes the foam base and
all adhesive tape holding the Beverage Cooler accessories inside
and outside.
2. Inspect and remove any remaining packing, tape or printed
materials before powering on the Beverage Cooler.
Leveling Your Beverage Cooler
• Your Beverage Cooler has two leveling feet which are located in
the front corners. After properly placing your Beverage Cooler in its
final position, you can level your Beverage Cooler.
• Leveling feet can be adjusted by turning them clockwise to lower
your Beverage Cooler or by turning them counterclockwise to raise
your Beverage Cooler. The Beverage Cooler door will close more
easily when the two front leveling legs are extended slightly.
Proper Air Circulation
• To ensure that your Beverage Cooler works at the maximum
efficiency it was designed for, you should install it in a location
where there is proper air circulation and electrical connections.
• The followings are recommended clearances around the Beverage
Cooler:
Sides............2" (50mm)
Top...............2" (50mm)
Back.............2" (50mm)
• Do not over fill your Beverage Cooler for proper cooling.
05
Publicité
