EINHELL Bavaria BPAS 14,4-2A Mode D'emploi page 8

Anleitung BPAS 14_4-2A_SPK1:_
GB
on the type and hardness of material in question
on the type and length screws used
on the requirements needing to be met by the
screwed joint.
The clutch disengages with a grating sound to
indicate when the set torque is reached.
Important! The tool must be at a standstill when
you set the torque with the setting ring.
Drilling
For drilling purposes, move the set-collar to the last
step „Drill". In this setting the slip clutch is inactive.
The maximum torque is available in drilling mode.
Forward/Reverse switch (3)
With the slide switch above the On/Off switch you
can select the direction of rotation of the battery-
powered drill/screwdriver and secure it against being
switched on accidentally. You can choose between
clockwise and anticlockwise rotation. To avoid
causing damage to the gearing it is advisable to
change the direction of rotation only when the tool is
at a standstill. The On/Off switch is blocked when
the slide switch is in centre position.
On/Off switch (4)
Infinitely variable speed control is possible with the
On/Off switch. The further you press the switch, the
higher the speed of the battery-powered
drill/screwdriver.
Battery capacity indicator
Press the battery capacity indicator button next
to the LCD display with the rechargeable battery
inserted. You can read off the present capacity of
the rechargeable battery in % from the LCD
display. A high percentage reading indicates that
the battery is fully charged; the percentage
reading is accordingly lower for a discharged
battery .
Screwdriving
We recommend using self-centering screws (e.g.
Torx screws, recessed head screws) designed for
reliable working. Be sure to use a bit that matches
the screw in shape and size. Set the torque, as
described elsewhere in these operating instructions,
to suit the size of screw.
8
14.02.2007 13:32 Uhr Seite 8
6. Technical data
Voltage supply 14,4 V d.c.
Speed 0-550 rpm
Torque 20 levels
Forward and reverse rotation
Chuck clamping width 0,8 - 10 mm
Battery charging voltage 18 V d.c.
Battery charging current 400 mA
Mains voltage for charger 230 V ~ 50 Hz
Sound pressure level L 64 dB(A)
pA
Sound power level L 75 dB(A)
WA
Vibration a < 2,5 m/s
hv
Weight
7. Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.
Maintenance
There are no parts inside the equipment which
require additional maintenance.
Ordering replacement parts
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
yes
2
1.64 kg