Weller WSM 1 Traduction De La Notice Originale page 18

EN
ENGLISH
rechargeable and regular batteries to a suitable collection
site. Do not dispose of them with household waste. Do not
attempt to open or destroy batteries. If fluid leaks from a
battery, make sure that this fluid does not come into contact
with your skin or eyes. If it does, clean your skin or eyes with
water immediately or seek medical attention.
The switching power supply used by Weller has a wide input
range and can therefore be connected to the mains voltage
range specified in the technical data.
The switching power supply must only be used in dry rooms.
Heat is generated during operation.
WARNING Fire hazard
For transport, the RT soldering tip should be removed
and the isolating switch should be set to „0" (rechargeable
battery version) to prevent the tool from being switched on
inadvertently.
Specified Conditions Of Use
Supply unit for WELLER soldering tools. Use the soldering
station only for the purpose of soldering, as specified in the
Operating Instructions.
Use the soldering iron exclusively for the purpose indicated
in the Operating Instructions of soldering and desoldering
under the conditions specified here.
The soldering iron may only used in combination with Weller
Supply Units.
This device may only be used at room temperature and
indoors. Protect against moisture and direct sunlight.
User groups
Due to differing degrees of risk and potential hazards, sever-
al work steps may only be performed by trained experts.
Work step
Default soldering para-
meters
Replacing electrical repla-
cement parts
Default maintenance
intervals
Operation
Filter change
Replacing electrical repla-
cement parts
18
User groups
Specialist personnel with
technical training
Electricians
Safety expert
Non-specialists
Technical trainees under
the guidance and supervi-
sion of a trained expert
Care and maintenance
WARNING
Before doing any work on the machine, pull
the plug out of the socket. Leave the unit to
cool down.
Check all connected cables and hoses on a regular basis. If
power tools are damaged, they must be immediately
removed from use.
Only replace the soldering tips when they are cold.
The soldering tool must be left switched off in the safety rest
for at least 3 minutes until the soldering tip has cooled down.
The LED status indicator must be at „OFF".
Keep the heat transfer surfaces of the soldering tip and
heating element clean. The heating element must not come
into contact with soldering tin.
Repairs must always be referred to a Weller-trained
specialist.
Use original replacement parts only.
Warranty
Claims by the buyer for physical defects are time-barred
after a period of one year from delivery to the buyer. This
does not apply to claims by the buyer for indemnification in
accordance with §§ 478, 479 BGB (German Federal Law
Gazette).
We shall only be liable for claims arising from a warranty
furnished by us if the quality or durability warranty has been
furnished by use in writing and using the term „Warranty".
The warranty shall be void if damage is due to improper use
and if the device has been tampered with by unauthorized
persons.
For more information please visit
www.weller-tools.com.