Technics SL-100C Manuel D'utilisation page 12

Connections and installation
 Turn off all units and disconnect the AC power supply cord from the socket before
making any connections.
 Connect the AC power supply cord only after all other connections are completed.
 Be sure to connect the PHONO earth lead. Otherwise mains hum may occur.
 Refer also to the instruction manual of the connected device.
Connecting to an integrated amplifier or component system
1
Turn off the unit and the
connected device, and disconnect
the AC power supply cord from the
socket.
2
Connect the PHONO cable and
PHONO earth lead to the PHONO
input terminals of the connected
equipment.
 You will not have adequate volume or
sound quality if the connected amplifier
has no PHONO input terminals.
Amplifier (not included)
PHONO PHONO
EARTH
L
R
Attention
 Tighten the PHONO earth terminal using a Phillips head screwdriver.
Note
 Stanby/on switch [
Press to switch the unit from on to standby mode or vice versa.
In standby mode, the unit is still consuming a small amount of power.
Remove the plug from the mains socket if you will not be using the unit for an extended period of
time. Place the unit so that the plug can be easily removed.
12
(12)
English
PHONO
OUT
PHONO earth lead
PHONO cable
] (OFF/ON)
3
Connect the AC power supply
cord.
 Confirm the wattage of the AC outlet on
the connected equipment before using it
for this unit.
For the power consumption of this unit,
see the specifications. ( 23)
Back of main unit
AC power supply cord
L
R
To a household
mains socket
Insert the AC power
supply cord up to a
point just before the
round hole.