Publicité
Les langues disponibles
Les langues disponibles
Product HANDBOOK
Input Parameters:
Standard
Rated input voltage
Input voltage range
Input frequency range
Maximum input current
115/240VAC
Inrush current
Class of Equipment
Overvoltage Category
Output Parameters:
Model
100W
Output connector mates with Molex housing 09-50-1081 and Molex 5194 series crimp terminal
Adjusting output voltage beyond the set value stated may cause overvoltage protection (OVP) to operate,
whereby the output will latch
output voltage to within its range and cycle the input off then on.
All outputs are SELV except under the following circumstance: Outputs connected in series are non-SELV if
the total output voltage exceeds 60Vdc
If the total voltage of outputs connected in series exceed the 60Vdc SELV limit then all outputs must be
considered non-SELV.
Non-SELV outputs are hazardous and must not be made user accessible. Consideration must be given to
service engineers making inadvertent contact with the output terminals in the end equipment.
Cooling for unit
The ZPSA100 series are convection cooled, recommended installation
Equipment top
ZPSA100 Series
100-240 VAC
90 – 264VAC
130mA/
0.70mA
30A max at 230VAC
Vout (V)
Output
current (A)
5
20
9
11.2
12
8.4
15
6.7
18
5.6
24
4.2
48
2.1
off.
To reset for normal operation simply adjust the potentiometer to reduce the
60950-1
47 – 63Hz
270mA/
400mA/
0.130mA
0.200mA
I
II
Publicité
