Ingersoll Rand RX-264H Manuel De L'opérateur page 7

EN
Maintenance
Observe the adjusting, maintenance and inspection activities
and intervals set out in the operating instructions, including
information on the replacement of parts and equipment. These
activities may be executed by skilled personnel only.
Ensure that the maintenance area is adequately secured.
After cleaning, examine all fuel, lubricant, and hydraulic fluid
lines for leaks, loose connections, chafe marks and damage.
Any defects found must be rectified without delay.
Always tighten any screwed connections that have been
loosened during maintenance and repair.
Any safety devices removed for set-up, maintenance or repair
purposes must be refitted and checked immediately upon
completion of the maintenance and repair work.
Ensure that all consumables and replaced parts are disposed of
safely and with minimum environmental impact.
AVOID, whenever possible, servicing, cleaning or examining the
unit with the engine running.
NEVER fill the fuel tank, with the engine running, while near an
open flame, or when smoking. ALWAYS wipe up any spilled fuel
immediately.
ALWAYS disconnect the spark plug before performing any work
on the unit.
DO NOT alter the engine governor settings from that indicated
in the engine manual.
ALWAYS replace damaged or lost decals. Refer to the Parts
Manual for the proper location and part number of all decals.
Carry out welding, flame-cutting and grinding work on the
machine only if this has been expressly authorized, as there
may be a risk of explosion and fire.
Before carrying out welding, flame-cutting and grinding
operations, clean the machine and its surroundings from dust
and other inflammable substances and make sure that the
premises are adequately ventilated (risk of explosion).
RX-264H/RX-344H Upright Rammer
v-EN Operation & Maintenance Manual