General Maintenance; Initial Break-In Maintenance - Ingersoll Rand RX-264H Manuel De L'opérateur

GENERAL MAINTENANCE

1. Engine RPM is adjusted to:
RX-264H: 4,000 – 4,100 min
RX-344H: 3,600 – 3,700 min
(With load)
2. Check Bolts and Nuts for looseness. Tighten it if necessary.
3. Check for fuel and oil leak.
4. Keep the RUBBER BUFFER operating handle away from oil
and fuel.
5. Please refer to "INSTRUCTION FOR USE" for HONDA
engine GX100 (RX-264H) or for HONDA engine GX120
(RX-344H) regarding the how-to maintenance for engine.
Air Cleaner
Keep the Air Cleaner Element clean. Take out the outer
urethane foam and inner element. Wash the element in
kerosene or diesel fuel. Saturate it in a mixture of 3 parts
kerosene or diesel fuel and 1 part engine oil. Shake off
excessive oil and reinstall. Wash the air cleaner case using
kerosene. After cleaning it up, apply the engine oil on the inner
part of the case.
CAUTION
If the air cleaner element is seriously contaminated,
start-up failure, poor output and malfunctions of the engine
may result.
Lubrication
Lubrication is an essential part of preventive maintenance,
affecting to a great extent the useful life of the unit. Different
lubricants are needed and some components in the unit require
more frequent lubrication than others.
Specific recommendations of brand and grade of lubricants are
not made here due to regional availability, operating conditions,
and the continual development of improved products. Where
questions arise, refer to the requirements and specifications in
the manufacturer's manual.
All oil levels are to be checked with the machine parked on a
level surface, and while the oil is cold, unless otherwise
specified.
-1
or rpm.
-1
or rpm.
Check Fuel
1. Stop the engine and open the fuel tank cap.
2. Use automobile unleaded gasoline only.
3. Close the fuel cock before filling the fuel tank.
4. When filling the fuel tank, always use the fuel filter.
5. Wipe off any spilled fuel before starting the engine.
Fuel is flammable. It may cause injury and property
damage.
Shut down the engine, extinguish all open flames and do
not smoke while filling the fuel tank.
Always wipe up any spilled fuel.

INITIAL BREAK-IN MAINTENANCE

Engine Oil
Drain the engine oil after the first 20 hours of operation. Fill with
the correct amount of the recommended oil. Check the oil level
with the oil filler cap/dip stick. See "50 HOUR OR WEEKLY
ROUTINE MAINTENANCE".
Hot oil and/or components can burn.
Oil must be at normal operating temperature when
draining.
Avoid contact with hot oil or components.
Lubrication of Main Body
Check the Main Body oil level with the oil gauge before each
operation. Change oil after the first 50 hours and every
200 hours. See "200 HOUR OR QUARTERLY ROUTINE
MAINTENANCE".
Check each part of lose or broken bolts and nuts
Tighten loose Bolts and Nuts, if any. Check each part for fuel oil
leak. Replace broken or damaged parts, if any, with new ones.
12-EN
WARNING
WARNING
RX-264H/RX-344H Upright Rammer
Operation & Maintenance Manual