Boost PLS Série Mode D'emploi page 4

If the remote control doesn't work properly, please check the batteries.
Installing the Batteries
Remove the battery cover from the back of the
remote control as shown and insert 2x AAA size
batteries ensuring correct polarity
1. Master volume control
2. BASS control: Adjustment of low frequencies
3. TREBLE control: Adjustment of high frequencies
4. Microphone volume control
5. Echo control for the microphone
6. Input for a wired mic (not supplied)
7. Priority on mic: reduces the volume of all other input sources
8. Switches the LED on the woofer on /off
9. When te power adaptor is connected, the indicator lamp will be lit a and the battery will charge
10. Lights up when the battery is fully charged
11. Wireless mic antenna: when you use the wireless microphone, please make sure the antenna is
pointing vertically upwards to optimize the reception.
12. 12V battery input: please make sure to connect the external battery with the correct polarity (+ and -).
The cable section must not be smaller than 0.75mm².
13. AUX input via RCA connectors
14. Input selector: Press this button to switch between the various inputs (AUX, USB, SD, Bluetooth, FM)
15. REC button: Press this button to record the sound of the wired or wireless mic on the USB or SD.
16. REPEAT: Press to toggle between repeating the current track or repeating all tracks.
17. In USB/SD/Bluetooth mode: press to go back to the previous track. In FM mode: press to go to the
previously stored FM station.
18. Play/pause in USB/SD/Bluetooth mode. In FM mode, press and hold this button to start searching for
radio stations and store them automatically in the memory
19. In USB/SD/Bluetooth mode: press to go to the next track. In FM mode: press to go to the next stored
FM station.
20. USB stick input
21. SD card input
22. Input connector for a guitar
23. Guitar volume control
24. ON/OFF switch of the system
25. AC input connector
26. LINE output to another active speaker, mixer, amplifier, etc.
CONNECTION OF A WIRED MICROPHONE (not included)
Connect the microphone to the MIC IN socket and switch it on.
Note: If you are playing music from any other input, connecting the microphone will not mute the sound
output.
USING THE WIRELESS MICROPHONE
Open the battery compartment and insert two AA batteries with the correct polarity.
Turn the switch on the mic to ON. If the power indicator lamp doesn't flash or doesn't light up, check if the
battery has been properly inserted.
©Copyright LOTRONIC 2016 BOOST-PLS series 4