FAR LV12C49N19S Manuel D'utilisation page 53

ENGLISH
Problem Possible Causes
Stained tub Detergent with
interior colourant may have
been used.
White film on Hard water
inside surface minerals.
There are The affected items
rust stains on are not corrosion
cutlery resistant.
A program was
not run after
dishwasher salt was
added. Traces of
salt have gotten into
the wash cycle.
The lid of the softer
is loose.
Knocking A spray arm is
noise in the knocking against an
dishwasher item in a basket
GB-32
What To Do
Make sure that the detergent
has no colourant.
To clean the interior, use a
damp sponge with dishwasher
detergent and wear rubber
gloves. Never use any other
cleaner than dishwasher
detergent otherwise, it may
cause foaming or suds.
Avoid washing items that are
not corrosion resistant in the
dishwasher.
Always run a wash program
without any crockery after
adding salt. Do not select the
Turbo function (if present),
after adding dishwasher salt.
Check the softener lid is secure.
Interrupt the program and
rearrange the items which are
obstructing the spray arm.
Problem Possible Causes
Rattling Items of crockery
noise in the are loose in the
dishwasher dishwasher.
Knocking This may be
noise in the caused by on-site
water pipes installation or the
cross-section of the
piping.
The dishes are The dishes were not
not clean loaded correctly.
The program
was not powerful
enough.
Not enough
detergent was
dispensed.
Items are blocking
the movement of
the spray arms.
The filter
combination is
not clean or is not
correctly fitted in
the base of wash
cabinet. This may
cause the spray arm
jets to get blocked.
ENGLISH
What To Do
Interrupt the program and
rearrange the items of crockery.
This has no influence on the
dishwasher function. If in
doubt, contact a qualified
plumber.
See PART II "Preparing And
Loading Dishes".
Select a more intensive
program.
Use more detergent, or change
your detergent.
Rearrange the items so that the
spray can rotate freely.
Clean and/or fit the filter
correctly. Clean the spray arm
jets.
GB-33