Publicité
Les langues disponibles
Les langues disponibles
LOADING THE BTFP12233
EYE PROTECTION which conforms to ANSI specifications and provides protection against
flying particles both from the FRONT and SIDE should ALWAYS be worn by the operator
and others in the work area when connecting to air supply, loading, operating or servicing
this tool. Eye protection is required to guard against flying fasteners and debris, which
could cause severe eye injury.
The employer and/or user must ensure that proper eye protection is worn. Eye protection
equipment must conform to the requirements of the American National Standards
Institute, ANSI Z87.1 and provide both frontal and side protection. NOTE: Non-side
shielded spectacles and face shields alone do not provide adequate protection.
TO PREVENT ACCIDENTAL INJURIES:
• Never place a hand or any other part of the body in nail discharge area of tool while
the air supply is connected.
• Never point the tool at anyone else.
• Never engage in horseplay.
• Never pull the trigger unless nose is directed at the work.
• Always handle the tool with care.
• Do not pull the trigger or depress the trip mechanism while loading the tool.
LOADING THE BTFP12233
1. Depress magazine release button and pull back magazine.
2. Open magazine fully and turn tool sideways with discharge area pointed away from yourself and others.
Load brads in channel.
3. Push magazine forward until latch is engaged.
TRIP OPERATION MODE
Always disconnect air supply before making adjustments as accidental actuation
may occur, possibly causing injury.
The BTFP12233 feature a selectable trigger system that allows the user to choose between the
following modes of operation:
1. Contact Trip Operation
2. Sequential Trip Operation
-8-
Publicité
