Télécharger Imprimer la page

WINDTECH Windsos Cube 100 Mode D'emploi page 8

Masquer les pouces Voir aussi pour Windsos Cube 100:

Publicité

Les langues disponibles

Les langues disponibles

8
> installation/setup
WINDSOs
The
CUBE can be installed in a ventral container or in the usual container of
our harness.
In both cases we must make sure of the correct connection. The cube has only 1 riser.
WINDSOs
The
CUBE is not equipped with a delayed opening system nor is it designed for
free fall, so the process will always be: first open the parachute by pulling the handle
and then release off the paraglider in case you need it and never the other way around.
The installation must always be carried out by specialists with extensive experience or
in a parachute inspection, folding and repair center, of course following the instructions
in this manual.
The inner container of the
points for the drive handle. One on top, one on the side and one on central part.
It is very important to choose the right one, depending on the location of our
CUBE. In case of using a ventral container, the most common will be the central anchor
point of the container. We will always check the correct functioning of the parachute
once it is installed in the harness or in the container, repeating the process if necessary
to verify that everything works correctly and that it can be removed easily.
WINDSOs
CUBE is equipped with three possible anchoring
WINDSOs

Publicité

loading

Produits Connexes pour WINDTECH Windsos Cube 100

Ce manuel est également adapté pour:

Windsos cube 125