Ryobi RY10521A Manuel D'utilisation page 13

FILLING THE FUEL TANK
See Figure 2.
 Clean the surface around the fuel cap to prevent
contamination.
 Loosen the fuel cap slowly, by turning counter-
clockwise.
 Carefully pour the fuel mixture into the tank.
Avoid spillage.
 Prior to replacing the fuel cap, clean and inspect the
o-ring.
 Immediately replace the fuel cap and hand
tighten, by turning clockwise. Wipe up any fuel
spillage.
 Move at least 30 ft. away from refueling area
before starting the product.
NOTE: It is normal for the engine to emit smoke
during and after the first use.
All manuals and user guides at all-guides.com
OPERATION
Fig. 2
Page 13 — English
ADDING BAR AND CHAIN LUBRICANT
See Figure 3.
Use RYOBI Bar and Chain Lubricant. It is designed
for chains and chain oilers, and is formulated to
perform over a wide temperature range with no dilu-
tion required. Chain saw should use approximately
one tank of lubricant per tank of fuel.
NOTE: Do not use dirty, used, or otherwise con-
taminated lubricants. Damage may occur to the
oil pump, bar, or chain.
 Carefully pour the bar and chain lubricant into
the oil tank.
 Fill the oil tank every time you fuel the engine.
Fig. 3