For Saving Energy - Panasonic NR-B32FX2-XE Mode D'emploi

Installation
Cleaning
After installation, wipe the appliance clean with warm water.
Connecting the mains plug to the household mains socket
You can connect the mains plug immediately after installation.
When the mains plug is connected to the household mains socket, the temperature display starts
flashing as shown in the figure on the right, and cooling starts inside the refrigerator.
The temperatures displayed at this time are not the actual temperatures.
When the temperature of the fridge reaches 8 °C, the freezer reaches -12 °C and the Vitamin-Safe
Zone reaches 8 °C, the temperature display stops flashing and lights, and it shows the actual
temperature.
It takes about half a day to reach the set temperatures (when the room temperature is around
32 °C, there is no food inside the refrigerator, and the doors are closed).
The actual temperatures may not be displayed for a while after the temperature display stops
flashing.
Place food inside the refrigerator only after confirming that the refrigerator compartment has been cooled.
Notes:
• Cooling may take longer in the summer months or at other times when the room temperature is higher.
• While the temperature display is flashing, the alarm sounds to warn that the temperature has risen. The alarm can be
turned off by pressing
• If you need to unplug the refrigerator, wait at least 10 minutes before you plug it back in again. If not, you might damage
the compressor.
Ambient room temperature
You'll find your refrigerator's climate classification on the rating plate in the left side of the refrigerator compartment. It
shows the room temperature the appliance is designed to work in.
Climate classification
SN
(Extended Temperate)
N
(Temperate)
ST (Subtropical)
T (Tropical)

For saving energy

1. Install the refrigerator in a dry, cool and well-ventilated location. The colder the ambient temperature, the better the
efficiency. (Please refer to Page 5 for dimensions and clearance)
2. The combination of drawers and shelves that result in the largest in volume and the most efficient use of energy for the
refrigerator.
• Remove all drawers in the freezer.
• Attach the drawers and shelves in the refrigerator to the positions illustrated on the section of "Parts" (P.7).
3. Do not over fill the refrigerator to allow the air to circulate.
4. Open the doors only when necessary and as briefly as possible.
5. Occasionally clean the ventilation openings at the bottom of the refrigerator with a vacuum cleaner, etc.
(Take care not to damage the refrigerant pipe inside the cover)
6. When setting to "Super Freeze Mode", power consumption will be increased.
6 6
(continued)
.
Permitted ambient temperature
+10°C to 32°C
+16°C to 32°C
+16°C to 38°C
+16°C to 43°C