Westinghouse WPX2300e Manuel D'utilisation page 11

ASSEMBLY
INSTALLING THE WHEELS
See Figure 4.
l Place the pressure washer on a flat surface.
l Lift the rear of the pressure washer high enough to gain
access to the bottom of the frame.
l Place props beneath the pressure washer to serve as a
temporary support.
l Locate the axles, wheels, washers, and hitch pins.
l Insert an axle through the middle of a wheel, washer, and
the frame as shown.
l Push a hitch pin into the axle until the center of the pin
rests against the top of the axle.
l Repeat these steps to install second wheel.
ATTACHING THE CORD RETAINER
See Figure 5.
l Align the holes in the cord retainer with the holes in the
frame.
NOTE: Install the cord retainer facing up as shown.
l Insert a bolt through the frame and the cord retainer.
Tighten to secure.
INSTALLING THE HANDLE
See Figure 6.
CAUTION
frame, use caution to avoid pinching your fingers or
hands.
l Slide the handle onto the frame until it contacts the buttons.
l Depress the buttons and continue sliding the handle down
into place.
l Pull the handle up until the buttons snap into the holes in
the handle.
NOTE: Make sure the handle is secure before operation.
When attaching the handle to the
FIG. 4
D
C
A - Axle
B - Wheel
C - Washer
D - Hitch pin
FIG. 5
A
A - Cord retainer
B - Bolt
FIG. 6
B
A - Handle
B - Button
B
A
B
A
B
English | 11