Westinghouse WPX2700e Manuel De L'utilisateur page 14

ASSEMBLY
NOTICE
ALWAYS turn the water supply "ON"
before turning the pressure washer power to "ON".
Running the pump dry of water will cause damage
to the internal components and render the pressure
washer inoperable.
OPERATION
WARNING
product unless instructed to so in this manual or
by the manufacturer. Do not use attachments or
accessories that are not recommended for use with
this product. Making unauthorized modifications
and using incompatible accessories can damage
the unit and may void your warranty.
WARNING
prevent injury to eyes when operating the pressure
washer.
WARNING
person, animal, electrical device, or the unit itself.
Failure to heed this warning could result in serious
injury, electric shock, or death.
WARNING
the off position when the unit is not being used.
STARTING AND STOPPING THE PRESSURE
WASHER
See Figure 13.
l Connect a garden hose as described previously and
turn the water on.
NOTICE
ALWAYS turn the water supply "ON "
before turning the pressure washer power to "ON".
Running the pump dry of water will cause damage
to the internal components and render the pressure
washer inoperable.
l Connect a garden hose and turn the water on.
l Completely unwind the power cord and connect it to a
grounded 120 volt outlet.
WARNING
off the ground. Do not touch the plug with wet
hands.
l Hold the spray gun with both hands and point the lance
in a safe direction.
14 | English
Do not alter or modify this
ALWAYS wear eye protection to
NEVER spray directly at a
ALWAYS turn the on/off switch to
Keep all connections dry and
OVERVIEW
This pressure washer can produce very high levels of
water pressure and can be used for a variety cleaning
applications such as cleaning decks and walkways,
washing vehicles and equipement; and removing dirt
from home exteriors and fences.
l Release the safety lock and squeeze the trigger
to release water and air out of the hose. Continue
squeezing the trigger until there is a steady stream of
water, then release and lock the trigger. Refer to Using
the Spray Gun later in this section.
l Turn the on/off switch to the on position to start the
pressure washer. The unit will run for several seconds
and shut off. This is a normal function of the auto-start
feature.
NOTE: The unit could be pressurized even if you don't
hear the motor and pump running. Always be cautious
when you are around a pressure washer.
l Turn the on/off switch to the off position to stop the
pressure washer.
FIG. 13
B
A - On/off switch
B - On position
C - Off position
C
A