Publicité
Les langues disponibles
Les langues disponibles
STEP 3 Connect the electrical wiring
First, read through the "Electrical requirements" section, and then follow these steps.
3-wire system
A
B
A. External ground connector
B. Neutral grounding wire (white)
C. Center silver-colored terminal block
screw
D. Neutral wire (white or center wire)
E. ¾" (1.9 cm) UL-listed strain relief
DV8650M-03170X-00_EN.indd 19
1. Loosen or remove the center terminal
block.
C
2. Connect the neutral wire (white or
center wire) of the power cable to the
center, silver-colored terminal screw of
the terminal block. Tighten the screws.
D
3. Connect the other wires to outer
E
terminal block screws. Tighten the
screws.
4. Tighten the strain relief screws.
5. Insert the terminal block cover into the
rear panel of the dryer. Then, secure the
cover with a hold-down screw.
CAUTION
• To convert from the 4-wire system
to 3-wire system, connect the ground
strap to the terminal block support to
ground the dryer frame to the neutral
conductor.
• Ring-type terminals are recommended.
If using strap terminals, make sure they
are tightened.
English 19
2017-01-06
4:36:56
Publicité
