EUROM 335781 Manuel D'utilisation page 25

the black locking screw (21) that is located at the top of
the top section of the stand.
 Push the centre section of the stand (16) into the lower
section (15), screw-hole to screw-hole. Secure with four
fixing screws. In the same way, secure the upper section
of the stand (17, with the adjustable part inside) over the
central section.
 Screw the extra black coloured screw (supplied) into the
adjustable section of the stand so that it cannot, so that it
cannot slide into the upper section (to secure the movable
pipe).
 Then undo the locking screw (21) almost entirely. Place
the top of the patio heater over the top of the adjustable
stand section so that the locking screw falls precisely into
the recess on the stand. Now tighten the locking screw
firmly. The electrical cable can be secured in the cable
holders on the stand.
 Check that all connections are completely secure and that the terrace heater is
securely positioned before using it. The terrace heater must be placed firmly on
an even and completely horizontal surface. The top of the patio heater can tilt to
around 30°; set it to the position you prefer.
Stand Golden 1800S
The stand that is supplied with the Golden 1800S is
multifunctional. In the top of the narrow stand section, there is a
threaded section; a suitable screw with a black top is also
supplied. You can, therefore, also mount a lamp on the stand
(see picture).
Patio heater functions
Golden 1800
 Check that all of the safety requirements have been fulfilled.
 Now insert the plug into the socket (220-240V~50/60Hz). The device will start
to radiate. You can stop it from operating by removing the plug from the socket.
Golden 1800S
The height of the heater top can be adjusted with the S-
system. The black locking screw (21) on the upper stand
section must be undone and the adjustable stand section
can be pushed in/out of the upper section. Then tighten
the screw up firmly. The heater head must always be kept
at least 180 cm above the floor.
 Check that all of the safety requirements have been
fulfilled.
 Ensure that the position switch (Y) is set to 0.
25