EUROM 335781 Manuel D'utilisation page 24

 Hook the radiator into the wall support and
check that everything is firm and is suspended
fully horizontally.
 Secure it by tightening the screw supplied
through the bottom hole of the bracket up
against the wall.
 Determine the direction of radiation. Your
terrace radiator has 4 positions: from straight
ahead to ± 30° downwards. Fix the device in
the required position using the 2 small screws
(B).
Wall mounting Golden 1800S
 Drill four holes in the correct places for the
plugs and attach the wall bracket (G) to the
wall using the screws. The curved part of the
plate must be uppermost and the 'keyhole'
must be located at the bottom of the support.
The wall bracket must be perfectly vertical.
 Attach the bracket (F) using the two small
screws on the patio heater, as shown.
 Turn the hanging screw (H) into the
corresponding hole on the side of the patio
heater, until it protrudes a maximum of 5 mm
(see diagram).
 Hang the heater onto the wall support. The
bracket at the back of the heater unit must fall into the curved part of the wall
support; the hanging screw (H) must be placed into the round part of the
'keyhole' on the wall support and then pushed gently downwards until the patio
heater is firmly affixed. Secure this with a bolt (E) through both brackets (see
diagram).
 Check that the patio heater is attached firmly and fully horizontally before use.
Assembling the stand (Golden 1800S)
 Place the bottom section of the stand (15, with
the fastening plate) on the base (14), in such
a way that the screw holes are aligned. Turn
the foot over and screw the lower section of
the stand from below with the plate and the
locking nut (see picture). Turn the base the
right way up. Place the protective cover over
the screw connection.
 Slide the adjustable, narrow section of the
stand (18) from below through the top section of the stand (17), until it comes
out again at the top (widening at the base). Secure the adjustable section using
24