Publicité
EXPLODED-VIEW ASSEMBLY DRAWING
EN
14
1. SEAT FRAME
2. FRONT INCLINE FRAME
3. ADJUSTIVE FRAME
4. LONG FOAM TUBE(A)
5. SHORT FOAM TUBE
6. LONG FOAM TUBE(B)
7. BIG ROLLER FOAM
8. SMALL ROLLER FOAM
9. SEAT
10. Φ38 ROUND END CAP
11. Φ19 ROUND PLUG
12. 34mm SQUARE PLUG
13. M8*50 HEX BOLT
14. M8 WASHER
15. M6*16 BOLT
16. M8 NYLON NUT
17. M8 KNOB
18. M8 KNOB
19. M6 WASHER
20. LOCK PIN
21. 30mm SQUARE PLUG
06
1
Place the front incline frame (2)
into the adjustive frame (3) and
attach the short foam tube (5) at
adjustive frame (3) in desired
position and secure with M8 Knob
(17). Attach the long foam tube (4)
at adjustive frame (3) in desired
position and secure with M8 Knob
(17). Slide big roller foam (7) on both ends of short foam tube (5).
Slide big roller foam (7) and small roller foam (8) on both ends of
x1
long foam tube (4).
x1
x1
x1
x1
2
x1
x6
x4
x1
x4
x8
x1
x1
x2
x6
x1
x2
x1
x6
x1
x2
ASSEMBLY DRAWING
Place the front incline frame (2) into the hole of seat
frame(1), locked with M8 Knob(18). Slide small roller
foam (8) on both ends of long foam tube (6).
07
Publicité
