Melchioni Family FACILE Manuel D'instruction page 16

IRONING INSTRUCTIONS
Fabric
Acrylic
Acetate
Nylon and Polyester
Rayon
Viscose
Silk
Cotton blends
Wool and wool blends
Cotton
Corduroy
Linen
Demin
Varying the ironing speed and the humidity of the fabric may cause the optimal setting to differ from that recommended
in the table
Tips: Always start ironing fabrics that require a low ironing temperature setting, then increase the
temperature setting for fabrics that require a higher temperature. The iron heats up faster than it
cools down.
HOW TO FILL THE TANK WITH WATER
Make sure the iron is turned off and the AC power cord is unplugged from the electrical outlet.
Turn the steam control
1)
position. Let the iron rest in an upright position.
Fill the water through the filling opening in the water tank, using the cup provided. Pour the
2)
water up to the "MAX" line on the tank.
The water level can be observed through the transparent part of the tank when the iron is
3)
placed vertically. When the water level goes down, fill the tank, following the procedure just
described in steps 1 to 3.
If the water is very hard, it is recommended to use only distilled water or demineralized water.
4)
Do not use scented water, vinegar or ironing products in the water tank as they may cause
splashes and stains.
Pour out the remaining water after use.
5)
NOTE: Most of the tap water can be used in this iron. Do not use water additives or scented water
in the iron, as they can stain the fabrics or damage the iron. Do not fill the water beyond the
"MAX".
Temperature setting
to "max"
to "max"
in the OFF position and the temperature control knob in the MIN
Tips for ironing
Dry iron inside out
Dry iron on the reverse while still damp or use a spray to
moisten
Iron inside out while still damp or use a spray to moisten
Iron on the wrong side of the fabric
Iron inside out. Use an ironing cloth to avoid shine marks
Check the label and follow the manufacturer's instructions. Use
the setting for the fiber that requires the lowest setting
Steam iron on the reverse side or use an ironing cloth
Steam iron on the reverse side or use an ironing cloth
Iron on the reverse side or use an ironing cloth to avoid shine
marks, especially with dark colors
Use the steam boost if necessary
15