Publicité
6. Starting a Washing Programme
Wash cycle table
Cycle Selection
Program
Information
For the heaviest soiled loads,
such as pots, pans, casserole
dishes and dishes that have
Intensive
been sitting with dried food
on them for a while.
Eco
For normally soiled loads,
such as pots, plates, glasses
(*EN60436)
and lightly soiled pans.
(Standard
Programme)
standard daily cycle.
For lightly and normally
soiled plates and pans
for every
day.(Run cycle
90min
immediately after use)
A shorter wash for lightly
soiled loads that do not
30min
need drying.
To rinse dishes that you
plan to wash later that day
Pre-Rinse
1.The ECO program is suitable to clean normally soiled tableware,it is the most efficent program in
terms of its combined energy and water consumption
2 Manual pre-rinsing of tableware items leads to increased water and energy consumption and is not
recommended .water and energy consumption and is not recommended .
3 Washing tableware in a household dishwasher usually consumes less energy and water than hand
dishwashing when the household dishwasher is used according to this instruction manual.
EN 60436: this program is the test cycle
The information for comparability test in accordance with EN60436, as follows:
-
Capacity:12 settings
- Position of upper basket :upper wheels on rails
- Rinse aid setting:6(or 4 for four setting dispenser)
Turning on the Appliance
Starting a wash cycle...
Draw out the lower and upper basket, load the dishes and
1. push them back. It is recommended to load the lower basket first, then the upper one (see the
section entitled "Loading the Dishwasher"). Pour in the detergent (see the section entitled "Salt,
Detergent and Rinse Aid").
2. Insert the plug into the socket. The power supply is 220-240V AC 50 Hz, the specification of the
socket is 12 A 250 VAC.50 Hz.
Make sure that the water supply is turned on to full pressure. Close the door, press the"Power"button,
16
Running
Description
Detergent
Energy
Time
Pre/main
of Cycle
(kWh)
(min)
Pre-wash
Main wash(60℃)
Rinse1
4/16g
180
1.300
Rinse2
Hot rinse
Drying
Pre-wash
Main wash(44℃)
4/16g
237
0.922
Hot rinse
Drying
Pre-wash
Main wash(50℃)
3/15g
90
0.890
Rinse
Hot rinse
Drying
Main wash(40℃)
15
30
0.500
Hot rinse
\
11
0.010
Pre-wash
Press the Programme button to select a desired "Wash cycle". (See the section entitled "Wash Cycle
Table") . With a little force to ensure the door is properly closed.
NOTE:
A click could be heard when the door is closed perfectly.
When the washing is over, you can shut off the switch by pressing "Power" button.
Switching on
Water
1. Open the tap, if it is closed.
(L)
2. Close the door.
3. Make sure the spray arms are not obstructed.
4. Switch the dishwasher on using the " Start/Pause " button.
16
Select a program
Choose your program according to the type of load and how dirty it is.
The different programs and their uses are described in the program chart later on in this
booklet. Use the program button to select the expected program .
11
Change the Program
Premise: A cycle that is underway can only be modified if it has only been running for a short time.
Otherwise, the detergent may have already been released, and the appliance may have already
drained the wash water. If this is the case, the detergent dispenser must be refilled (see the section
14
entitled " Fill in the Detergent " ).
1:Press the "Power" button to cancel the program.
2:Turn on it again and restart a new washing cycle (see the section entitled "Starting a wash cycle. . . " )
or press program button to change the program.
7
NOTE: If you open the door when the washing cycle underway, the appliance will pause and emit
warning signals, the digital display show "E1" and flash. When you close the door, the machine will
4
keep on working after 10 seconds.
Forget to Add Dish
A forgotten dish can be added any time before the detergent cup opens.
1 Open the door a little to stop the washing.
2 After the spray arms stop working, you can open the door completely.
3 Add forgotten dishes.
4 Close the door, the dishwasher will work after ten seconds.
WARNING!
It is dangerous to open the door when washing, because the hot water may scald you.
Switch Off the Dishwasher
The digital display appears "---", only in this case the program has ended.
1.Switch off the dishwasher by pressing the"Power" button. Or just wait for 30 minutes, the power
supply will automatically disconnect.
2.Turn off the water tap!
Open the door carefully. Hot steam may escape when the door is opened!
■Hot dishes are sensitive to knocks. The dishes should be allowed to cool down around
15 minutes before removing from the appliance.
■Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes. In
this way they will be cooler and the drying will be improved.
Unloading the dishwasher
It is normal that the dishwasher is wet inside.
Empty the lower basket first and then the upper one. This will avoid water dripping from the upper
basket onto the dishes in the lower one.
17
Publicité
