Herschel HS500PR Instructions D'installation Et D'utilisation page 5

Setup
Select Portable Infrared Panel Heater
1. Find the two feet supplied in the
package.
2. Fit to the long lower side of the heater.
The SMART-R power box at the back of
the panel should be at the bottom edge
of the heater.
3. Use a screw driver to tighten the friction
screws against the rear surface of the
heater. (Note: tightening the screws
against the front will damage the front
surface of the heater).
The Select Portable Infrared Panel Heater
comes with a factory fitted plug and can be
plugged into an available socket in the
room.
The SMART-R receiver allows your Portable
heater to operate in two different ways
according to preference:
• It will heat to a fixed temperature you set
on the receiver when you switch the
heater on at the wall.
• It can connect to wifi and be managed via
the SmartLife App.
Controls on the SMART-R receiver are as
follows:
1. LED
temperature
2. Wifi indicator
3. Timer On/Off indicator
4. On / Off button
5. Manual pairing button
6. Manual Temperature Increase
7. Manual Temperature Decrease
8. Built-in Thermostat.
9. Power Switch (I = On, O = Off)
10. Mains cable.
ENGLISH
display showing setpoint