Publicité
ASSEMBLY INSTRUCTIONS
Blower Assembly
THE BLOWER ASSEMBLY MUST BE DISCONNECTED FROM THE SOURCE OF ELECTRICAL SUPPLY BEFORE ATTEMPTING
THE INSTALLATION.
THE BLOWER ASSEMBLY IS INTENDED FOR USE ONLY WITH A STOVE THAT IS MARKED TO INDICATE SUCH USE.
5
DO NOT ROUTE THE SUPPLY CORD NEAR OR ACROSS HOT SURFACES!
LES EXTRÉMITÉS COUPÉES DU JOINT DE VERRE
Step 1.
DOIVENT SE RENCONTRER AU BAS ET AU CENTRE DU VERRE.
Fix the assembly to the back of the stove with the four screws provided.
6
C LES EXTRÉMITÉS COUPÉES DU JOINT DE VERRE DOIVENT
SE RENCONTRER ENTRE LES PATTES D'ARTICULATION.
4
9
8
ASH PAN ASSEMBLY
Remove ash pan from firebox. Under the firebox, there are two brackets; Slide the ash pan into these brackets.
10
1
-4-
Publicité
