Wolf 100410 Mode D'emploi page 3

Bluetooth Operation
•
Turn on the Bluetooth function on your mobile phone or any other external Bluetooth
devices.
Search for 8WOLF Helmet PRO9 on your Bluetooth device, and pair them. When paired,
•
<Bluetooth Connected= is shown on the LCD screen.
• Press Menu, to play/pause the music or answer a call. Tap Tune + or Tune – to
forward/rewind the songs. To reject the call, long-press Tune - for 2 seconds.
•
When on a call and receiving 2nd call: Sound is heard from the headset while the 1st call is
still in communicating > User can select to pick up the 2nd call via mobile phone > If pick up
the 2nd call, the 1st call is on hold > Resume the 1st call communication via mobile phone
after hang up the 2nd call.
•
If user ignores the 2nd call, no operation is needed.
•
Re-dialing, long-press Tune + for 2 seconds, it will re-dial last call. When you receive a call
through the Bluetooth function, it overrides the sound from FM/DAB+. Even pressing
Mode activates nothing until the mobile call ends.
•
After paired, the user still receives and answers a call while in Radio mode.
FM Operation
• Press the <Mode= Button to switch to FM. Press <Enter= to confirm the setting. Long-press
Tune - or Tune + to start scanning. Stop scanning when clear signal is received.
•
Manual search by short pressing Tune - or Tune +.
•
To review the station information, press if RDS message is available from the service
provider.
•
To save and listen to your favorite stations, refer to the steps of DAB+ preset stations as
mentioned above.
•
Short press Enter key, Audio mode selected to Mono / Auto, it is only for FM mode.
Bass Boost
• To enhance the bass performance, press Enter, <Bass= is shown on the display. To
deactivate the bass Boost function, press Enter again until <Bass= disappear from the
screen.
Boom Mic Jack
•
To connect the WOLF Boom Microphone, plug the WOLF Boom mic into the 3.5mm boom
mic jack port of the hearing protection.
Factory reset
•
All preset stations and other settings will be deleted.
• Press and hold the Menu button, press Tune - or Tune + to find 9System Reset9. Press Enter.
Software version
• Press Menu and then press Tune - or Tune + to find 9Software version9. Write it down here:
Safety helmet with earmuffs combination
•
The earmuffs are certified with the following helmets: see final page.
•
Other models may be compatible with the WOLF 30mm helmet clip, but the ear muffs
should only be used with the helmets stated on the final page.
100410 WOLF Helmet PRO
3/64