FAR MP2024W Mode D'emploi page 22

ENGLISH
INSTALLATION
P osition the appliance and allow it to stand for
two to three hours before it is turned on for
the first time to allow the system to settle. Do
not position next to any heat source e.g. cooker,
b oiler or in direct sunlight etc.
Allow at least 10 cm of space at the top and
10 cm of space on both sides of the appliance and
between the back of the appliance and the wall
for adequate air circulation.
d esigned for recessed installation ("building in").
Install on a good firm level surface, and any
unevenness of the floor should be corrected
prior to installation, slight unevenness can be
overcome by adjusting the front feet.
NOTE: If the appliance is positioned on a
carpet, soft floor covering you should readjust the
f ront feet once the appliance has had time to settle.
USE
• Remove all packaging materials from the
appliance. Wash the inside of the cabinet with
lukewarm water and bicarbonate of soda (5
ml to 0.5 liter of water). Dry the appliance
thoroughly.
GB-8
e appliance is not
SETTING THE THERMOSTAT KNOB
e refrigerator is controlled with a thermostat
k nob located inside the fridge, towards the
upper right-hand corner. Turn the knob from
t he STOP (OFF) position towards the higher
number for colder temperatures.
be adjusted from setting MIN to MAX.
Changes of the ambient temperature affect
temperature in the interior of the appliance
s o choose a correct setting of the temperature
control knob, depending on your ambient
conditions.
In the STOP (OFF) position the appliance does
not operate (the cooling system is switched off),
but power supply is not interrupted.
Set the thermostat knob to a middle position to
get 4 to 6°C in the fridge.
Place the food in different compartments according
to the following table.
· Foods with natural preservatives, such as
jams, juices, drinks, condiments. (Use
Door or balconies of fridge
within 1-2 days)
compartment
· Do not store perishable foods.
ENGLISH
e know can
Type of food
GB-9