Publicité
Les langues disponibles
Les langues disponibles
E
TROUBLE SHOOTING
Do not repair or disassemble the air conditioning. Unqualified repair will
invalidate the warranty and may lead to failure, causing injuries and property
damage. Only use it as directed in this user manual and only perform operations
advised here.
Problem
Reasons
There is no electricity.
The ambient temperature is too
low or too high.
In cooling mode, the room
temperature is lower than the
desired temperature; in heating
The air
mode, the room temperature
conditioner does
is higher than the desired
not work.
temperature.
In dehumidification (dry) mode,
the ambient temperature is low.
Doors or windows are open;
there are a lot of people; or in
cooling mode, there are other
sources of heat (e.g. fridges).
Doors or windows are open;
there are a lot of people; or in
cooling mode, there are other
sources of heat (e.g. fridges).
The cooling or
heating effect is
The filters screen is dirty.
poor.
The air inlet or outlet is blocked.
The unit is not straight.
The air
conditioner is
leaking.
The drain pipe is blocked.
Compressor does
Overheat protection operational.
not work.
The distance between the
machine and the remote control
is too far.
The remote
control does not
The remote control is not aligned
work.
with the direction of the remote-
control receiver.
Batteries are dead.
If problems not listed in the table occur or recommended solutions do not work,
please contact the service centre.
Solution
Check the unit is plugged in, and
the socket is working normally.
Only use to use the machine with
a room temperature between 7
and 35°C.
Adjust the desired room
temperaure.
Ensure that the room
temperature is above 17°C for dry
mode.
Close doors and windows;
increase air conditioning power.
Close doors and windows;
increase air conditioning power.
Clean or replace the filter screen.
Clear obstructions; make sure
the unit is installed as per the
instructions.
Use a spirit level to check the unit
is horizontal, if not remove from
the wall and straighen.
Check the drain pipe to ensure it
is not blocked or constricted.
Wait for 3 minutes until the
temperature is lowered, and then
restart the machine.
Let the remote control get close
to the air conditioner, and make
sure that the remote control
directly faces to the direction of
the remote-control receiver.
Replace batteries.
4
123
Publicité
