LG LRE6325ST Manuel D'installation page 8

8 PREPARE TO INSTALL THE RANGE
INSTALLATION DRAWINGS (LDE Series only)
NOTE
SAVE FOR THE USE OF THE LOCAL ELECTRICAL
INSPECTOR.
CLEARANCES AND DIMENSIONS (Figure 1)
To install range refer to the following Figure 1.
For installation in CANADA, a Free-standing range is
not to be installed closer than
adjacent surface.
CAUTION
• Make sure that the wall covering, countertop
and cabinets around the range can with-stand
the heat (up to 194°F) generated by the range.
- Discoloration, delamination or melting may
occur.
- This range has been designed to comply
with the maximum allowable wood cabinet
temperatures of 194°F.
A = 30"(76.2 cm) For U.S.A
= 30"(76.2 cm) ~ 31"(78.7 cm) For CANADA
MINIMUM DIMENSIONS (Figure 2)
* 30"(76.2 cm) minimum clearance between the top of the cooking surface and the bottom of an unprotected wood
or metal cabinet; or 24"(60.9 cm) minimum when bottom of wood or metal cabinet is protected by not less than
/ "(6.4 cm) flame retardant millboard covered with not less than no. 28 MSG sheet steel, 0.015"(0.381 mm) stainless
1
4
steel, 0.024"(0.610 mm) aluminum or 0.020"(0.508 mm) copper.
** 15"(38.1 cm) minimum between countertop and adjacent cabinet bottom.
/ (12mm) from any
15
32
Cabinet
opening
Cabinet
6" 6"
(15.2cm) (15.2cm)
4"
(10cm)
(10cm)
FIgURE 1
WARNING
• You should use two or more people to move and
install range. (Excessive Weight Hazard)
- Failure to do so can result in back or other injury.
• You never pull or push any handles of upper &
lower door to move and install range.
- Failure to do so can result in serious damage to
the door of the range.
CAUTION
• Cabinet storage space located above the
surface units should be avoided.
• Install a range hood that projects horizontally
a minimum of 5 inches beyond the bottom
of the cabinets. If cabinet storage is to be
provided.
- The risk of burns or fire by reaching over the
heated surface elements can be reduced.
Wall
Center
2.5"(6.3cm) 2.5"(6.3cm)
5"
6"
(13cm)
(15.2cm)
2.5"
4"
(6.3cm)
FIgURE 2