NAX 5000S Mode D'emploi page 46

29 (Rys.(Fig.) 25).
5. Sprocket, drive carrier 28 (Rys.(Fig.) 25) and the gear shaft must be cleaned of grease residues and lightly grease the above
elements. The recommended grease for this operation is NAX bevel gear grease.
CAUTION! Lubricate the gear wheel from the inside 27 (Rys.(Fig.) 25). Do not lubricate the outer rim on the sprocket
and the drive wheel.
6. Refit the entire mower drive mechanism in reverse order.
TRANSPORTATION
PREPARATION FOR TRANSPORT
 Before transporting the mower, remove oil, then: cool the engine, remove fuel from the tank, carburettor and fuel lines.
 The device can only be transported in the working position, i.e. at an angle of up to 15 degrees above the level.
 The handle may be folded.
Attention! Be careful when folding or unfolding the handle, as the cables may be damaged. Damaged cables can cause the
mower to malfunction and in some cases reduce the safety of use of the device.
46 EN