NAX 5000S Mode D'emploi page 43

outlet cover (Rys.(Fig.) 11), then lower the cover.
3. Make sure the hooks are attached correctly.
Warning! Often check the technical condition of the grass basket. If any parts are worn or damaged, they must be replaced
with new parts that are available at authorized service centers.
EMPTYING THE GRASS BASKET
Warning! Stop the engine before emptying and removing the basket.
Basket full indicato (Rys.(Fig.) 2) allows you to quickly assess the level of basket filling. If the indicator plate is raised while the
mower is running, it means that the basket is not full yet. If the indicator plate is raised while the mower is running (Rys.(Fig.) 12 A),
it means that the basket is not full yet. If the indicator plate is in a horizontal position during the mower's operation (Rys.(Fig.) 12 B),
it means that the basket is full and should be emptied.
SETTING THE FRONT WHEELS
Due to the special design of the front wheels, the mower is extremely manoeuvrable. Wheel alignment is set when the clamping device
snaps into place 19 (Rys.(Fig.) 13). If we want to change the wheel position:
1. lift the bracket to release it,
2. put the wheel in a new position,
3. snap the mounting brackets back into place.
In order for the front wheels to move freely, the clamping brackets must be raised 19 (Rys.(Fig.) 13) and do not put them in the hole, but
place them on the plate next to it (Rys.(Fig.) 13 pkt. A).
CLEANING THE CUTTING UNIT CABINET
Warning! When the engine is running, the cutting blades rotate.
1. After finishing work, thoroughly clean the entire device.
2. Stop the engine and disconnect the spark plug wire before cleaning the housing.
3. Empty the fuel tank before cleaning.
4. Without tilting the mower to the side, lay it on the ground so that the front wheels are in the air.
5. Clean the underside of the mower with a brush and water.
Do not use high-pressure cleaning devices, as high-pressure water can break the paint protection of the housing. Do not use intensive
cleaning and washing agents, e.g. aggressive detergents, they can damage plastics and metals, which may result in deterioration
of the device's safety.
The second way to clean the housing is to use the housing cleaning system.
After connecting the hose to a special quick coupler that is already mounted in the mower housing and unscrew the water, start the mower.
The device is cleaned during the rotation of the knife, on which a strong stream rinses out flushing residues of grass. (Rys.(Fig.) 14)
MOUNTING THE SIDE DISCHARGE CHUTE
To mount the side discharge chute:
1. open the side ejector cover 18 (Rys.(Fig.) 2) (To unlock the cover, first turn the axle cover (Rys.(Fig.) 16A, B)),
2. push in the side discharge chute 20 (Rys.(Fig.) 2) as shown in Rys.(Fig.) 16C,
3. rest the side ejection cover on the side discharge chute (Rys.(Fig.) 16D).
MULCHING FUNCTION
Mulching is a care procedure involving the fragmentation of cut grass. The mulching system allows it to be left completely or partially on
the soil, where it decomposes and provides nutrients.
The lawn meets the mulching conditions when the grass is no more than 4 cm. The lawn on which mulching will be carried out must be
mowed regularly and quite often - even every few days. During mulching, only young and delicate blades can be left on the surface, without
damaging the lawn, as they break down and do not rot.
To start the grinding function, remove the grass catcher and remove the side ejection cover (if fitted), mount the grass grinding attachment
/plug (Rys.(Fig.) 15) to the rear outlet and close the tailflap.
For mulching to be fully effective, you must buy a milling knife.
EN 43