Johnson JCRL10B Guide D'utilisation page 26

SET function
SET
Press the SET button to enter the function setting, then press SET button or TEMP
TEMP button to select the desired function. The selected symbol will flash on the
display area, press the OK button to confirm.
To cancel the selected function, just perform the same procedures as above.
Press the SET button to scroll through operation functions as follows:
Breeze Away* (
[ * ]: If your remote controller has Breeze Away button or Fresh button, you can not use
the SET button to select the Breeze Away or Fresh feature.
Breeze Away function (
This feature avoids direct air flow blowing
on the body and makes you feel indulging
in silky coolness.
NOTE: This feature is available under cool,
Fan and Dry mode only.
FRESH function (
the FRESH function is initiated, the Ionizer/
Plasma Dust Collector(depending on
models) is energized and will help to
remove pollen and impurities from the air.
Sleep function (
The SLEEP function is used to decrease
energy use while you sleep (and don't
need the same temperature settings to
stay comfortable). This function can only
be activated via remote control. For more
details see "Sleep operation" in the user's
manual.
Note: The SLEEP function is not
available in FAN or DRY mode.
SET
or
) > Fresh* ( ) > Sleep (
) (some units):
) (some units): When
) :
) > Follow Me ( ) > AP Mode ( )
Follow me function (
The FOLLOW ME function enables the
remote control to measure the temperature
at its current location and send this signal
to the air conditioner every 3 minutes
interval. When using AUTO, COOL or HEAT
modes, measuring ambient temperature
from the remote control (instead of from
the indoor unit itself) will enable the air
conditioner to optimize the temperature
around you and ensure maximum comfort.
NOTE: Press and hold Turbo button for
seven seconds
feature of Follow Me function.
If the memory feature is activated,

"On" displays for 3 seconds on the
screen.
If the memory feature is stopped,

"OF" displays for 3 seconds on the
screen.
While the memory feature is activa-

ted, press the ON/OFF button, shift
the mode or power failure will not
cancel the Follow me function.
AP function (
Choose AP mode to do wireless network
configuration. For some units, it doesn't
work by pressing the SET button. To
enter the AP mode, continuously press
the LED button seven times in 10
seconds.
13
):
to start/stop memory
) (some models):
V.1
OK
or