Bosch MES3500 Mode D'emploi page 12

en Contents
Congratulations on the purchase of
your new Bosch appliance. You can find
further information about our products
on our website.
Contents
Intended use . ............................................10
Important safety information .....................10
Overview...................................................12
Start lock-out ............................................12
Operation . .................................................12
Cleaning and maintenance . ......................14
Recipes.....................................................14
Disposal . ...................................................15
Guarantee.................................................15
Overview
Please fold out the illustrated pages.
X Fig. A
1 Motor unit (with cord store)
2 Switch
f = Switch off appliance
1 = Switch on appliance / low speed
2 = Switch on appliance / high speed
3 Catch
4 Pulp container
5 Lock for the outlet (drip stop)
Important information
– When switching on the appliance,
ensure that the lock is open (lock at the
very front). When the lock is open, the
juice flows into the juice jug.
– Before emptying the juice jug, switch
off the appliance (f) and close the
lock (push backwards). This will stop
more juice from running out and prevent
soiling of the work surface.
6 Filter tray with outlet
7 Filter
8 Lid
9 Filling shaft
10 Pusher
11 Juice jug
12 Foam separator
13 Lid for juice jug
14 Cleaning brush
12
Start lock-out
The appliance cannot be switched
on unless
– the filter tray and lid have been attached
correctly and
– the catch has been locked and engaged
correctly.
Before using the appliance, always check
that the lid is locked!
Operation
X Fig. B
Assembly
W Risk of injury
– Do not use the appliance if the power
cord and/or appliance are damaged.
– Before use, always check the entire
appliance, in particular the filter and filter
tray, for damage (cracks, flaws).
– Do not touch shredding blades /
blades on the base of the filter.
■ Push lock (with the handle to the left)
all the way onto the outlet and turn
upwards by 90°. Ensure that the sealing
ring is on the outlet!
■ Insert filter tray into the motor unit.
■ Insert filter and press down until it
clicks into position. The filter must fit
firmly on the drive! Check for damage
beforehand!
■ Insert the pulp container into the
motor unit.
■ Attach the lid.
■ Attach both catches to the lugs
on the lid (1.) and press down until they
click into position (2.).
■ Place juice jug with the spout under
the outlet. Remove foam separator
from the juice jug if you prefer juice
with foam. Place lid on the juice jug to
prevent splashes.
■ Insert pusher into the filling shaft.
Pusher has a guide groove!