Publicité
3.3.6
INNER &
OUTER GLASS PANEL REMOVAL & INSTALLATION.
BE VERY CAREFUL WHEN HANDLING THE GLASS. DO NOT DAMAGE
OUTER GLASS PANEL REMOVAL
1/. Do not attempt removal until fireplace and glass are cool to touch. Remove front air intake louver
2/. Unscrew the 3 front thumbscrews at the bottom so they are loose and slide back towards yourself
3/. Install glass suction cup lifter, do not attempt removal without suction lifter firmly attached.
4/. With aid of suction lifter, lift glass straight up, then while lowering the glass, carefully angle bottom towards you
and past front of fireplace until cleared at the bottom. Be extra careful so as not to damage glass.
5/. Removal of the front and side panels of glass is the same, but side panels do not have to be removed unless
damaged
INNER GLASS PANEL REMOVAL.
1/. Do not attempt removal until fireplace and glass are cool to touch. Remove inner louvers before attempting to
remove the glass.
2/. Install glass suction cup lifter, do not attempt removal without suction lifter firmly attached.
3/. Remove the top 3 thumbscrews
4/. Hold suction cup lifter and loosen the bottom 3 screws, unlike the top thumbscrews these do not
need to be completely removed but leave the bottom channel in place.
5/. With aid of suction lifter, lift glass straight up, then while lowering the glass, carefully angle bottom towards you
and past front of fireplace until cleared at the bottom. Be extra careful so as not to damage glass.
6/. The inner side glass should not need to be removed unless damaged as it is easily accessible once the front glass is
off
INNER GLASS PANEL INSTALLATION.
Carefully angle the front glass up into the top of the fireplace then lower into bottom glass channel. Lightly tighten the 3
thumb screws at the bottom. Install 3 thumb screws lightly to hold the top of the glass. Make sure the glass is even with
the side glass then hand tighten all 6 thumb screws. Be careful not to damage silicone strips on glass edges.
OUTER GLASS PANEL INSTALLATION.
Replace the inner louvers before installing the outer glass.
Installation of the outer sides and front glass is the same. The outer glass panel with the glass support strip on, fits up
into 2 clips at the top of the fireplace as shown in the diagram below. Once top is in the clips push the bottom of the
glass in and slide down until it locks into the brackets at the top, tighten the thumb screws lightly. Make sure the glass is
aligned with the side glass and is installed properly before tightening the thumb screws.
Thumb screws
Page 38 of 58
Publicité
