Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions
Component Installation
Locate the temperature and pressure relief valve, drain valve, and inlet/outlet fittings in the packaging of your water heater.
Remove and discard all gray colored plugs that were placed in the fitting openings of the water heater for shipping.
Refer to illustrations below for installing each component to the water heater.
After completing installation of all components, make sure to check all connection points for water leaks and correct if
required.
Tools needed:
• Pipe wrench
• Adjustable wrench
• Pipe joint compound or pip thread sealant tape
49-6000247 Rev. 1
Install Temperature and
Pressure Relief Valve
Install
Drain
Valve
Install
Outlet
(Hot)
Fitting
Install
Inlet
(Cold)
Fitting
11
Publicité
